ISSN: 2319-9873

Reach Us +44 7456 035580
All submissions of the EM system will be redirected to Online Manuscript Submission System. Authors are requested to submit articles directly to Online Manuscript Submission System of respective journal.

Effect of Exhaust Gas Recirculation on Performance of Petrol Engine

Tairu OO* and Tairu OT

Department of Mechatronics Engineering, Yaba College of Technology, Nigeria

*Corresponding Author:
Tairu Onawale O
Department of Mechatronics Engineering
Yaba College of Technology, Nigeria
Tel:
+2348023235284
E-mail:
onatairu@gmail.com

Received Date: 04/02/2017; Accepted Date: 12/06/2017; Published Date: 18/06/2017

Visit for more related articles at Research & Reviews: Journal of Engineering and Technology

Abstract

Exhaust gas recirculation is a method of reducing the emission of internal combustion engine. The principle is based on the thermodynamic properties of the exhaust gas, reduction in combustion temperature and hence reduces the emission of the oxides of nitrogen. The technical involves the recirculation of high heat capacity of the exhaust gas to dilute the charges 2.6% of the total exhaust gas from the engine was recycled from the exhaust gas discharge manifold to the intake manifold. The changes on the parameters of the engine were observed. The resulting data were analyzed graphically. It was found out that the exhaust gas recirculation increased the Brake specific fuel consumption, reduced the flame temperature and the speed of the engine.

Keywords

Exhaust, Recirculation, Temperature, Specific

Introduction

Oxides of nitrogen (NOx) are formed when temperatures in the combustion chamber get too hot [1,2]. At high temperature, the nitrogen in the combustion chamber chemically combine to from nitrous oxides, which, when combine with hydrocarbons (HCs) and in the presence of sunlight, produce an ugly hazard in our skies know commonly as smog [3,4]. Nitrogen and oxygen will unite to from oxides of nitrogen at rich fuel/air ratio mixture and high temperature while weak fuel/air ratio is needed to the control of the hydrocarbon and carbon monoxide. Since the fuel/air ratio cannot control the production of pollutants simultaneously in the engine. It is necessary to reduce the oxides of nitrogen and other unwanted particulates in the emissions from internal combustion engine. The introduction of exhaust gas recirculation is used to reduce the formation of the oxides of nitrogen. The exhaust gas recycled through the intake manifold back to the engine cylinders. Inter mixing the incoming air with recycled exhaust gas diluted the mix with inert gas, lowering the peak combustion temperatures and reduced the amount of excess oxygen as well as reduced the flame speed thus gave a useful reduction in formation of nitrogen without compromising the fuel economy. Exhaust gas recirculation (EGR) system were introduced in the early ‘70s to reduce an exhaust emission that not being cleaned by the other smog controls. The research and implementation of Exhaust gas recirculation started when the catalyst technology was not sufficient to reduce the formation of NOX [5,6]. The approach reduces the combustion temperature and increase engine efficiency. The fuel mixture diluted with air [7] or exhaust gas recirculation (EGR) [8]. EGR has high potential to reduce exhaust gas emission, particular NOX emission [9] and the amount of oxides of nitrogen formed could be reduced better with Exhaust gas than air [10]. It reduced NOX formation from 25.4% up to 89.6% [11].

The initial concentration of NOx when the engine was cooler at startup was higher than the concentration of NOx when the engine was warmer [12]. The reduction NOx concentration substantial claimed be achieved from 10% of EGR [13,14] and increased the brake specific fuel consumption. The effect of 1.6% of exhaust gas recirculation are on the flame temperature, the speed and fuel consumption were consider in this paper.

Description of Experimental Procedure

The engine of specification in Tables 1 and 2 was allowed running for thirty minute and pressure of the cooling water was reduced. The throttle control was used to change the speed. The exhaust gas was recirculated with the aids of the hose connected the exhaust manifold to the intake manifold. The percentage of area of connected pipe to the area of the intake manifold pipe was 2.6%. The temperatures of the exhaust gas and the cooling water at the inlet and outlet, the fuel consumption and the flow rate of the cooling water were taken with the corresponding speed for overheated with and without exhaust gas recirculation at the particular throttle positions at ten minutes interval.

Table 1. Specification of the engine.

Engine Manufacturer Toyota 4k
Engine properties 8 –valve OHV
Number of stroke 4
Number of cylinder 4
Cylinder bore 75 mm
Stroke 73 mm
Maximum Torque 103 Nm@3600rpm
Maximum Power 53 KW@5600rpm
Compression ratio 9:1
Cooling system water
Brake mean effective pressure 1003.4Kpa

Table 2. Nomenclature.

Speed N (rpm)
Fuel consumption Vf (cm3/min)
Exhaust gas temperature Te(°C)
Brake specific fuel consumption BSFC (g/KWh)

Results and Discussion

The results obtained from the experiment shown in Table 3. The effect of EGR on the speed, fuel consumption, brake specific fuel consumption and the exhaust gas temperature were shown on the table and the graphs were plotted for analysis.

Table 3. The readings obtained for the experiment.

Throttle Position Without EGR   With EGR  
N (rpm) Vf (cm3/min) Te (°C) BSFC (J/KWh) N (rpm) Vf (cm3/min) Te (°C) BSFC (J/KWh)
1 1000 17.64 75 1.25 950 17.64 63 1.32
2 1200 21.17 85 1.25 1150 22.93 65 1.41
3 1400 28.22 95 1.43 1300 29.46 73 1.60
4 1600 35.28 105 1.56 1400 36.52 80 1.85
5 1800 40.57 124 1.60 1650 42.34 95 1.82
6 2000 42.34 139 1.50 1850 44.10 100 1.69
7 2200 45.86 159 1.48 2050 47.63 123 1.65
8 2400 52.92 180 1.56 2200 58.21 150 1.87

Effect EGR on the Speed of the Engine

As shown in the Figure 1, the EGR reduced the speed of the engine. The speed minimum reduction is 5% and maximum reduction is 12.5%, the average reduction in speed is 7.5% as could be obtained in the Table 3. This due to the reduction in rate of combustion in the engine since the EGR diluted the concentration of air-fuel mixture of the combustion.

engineering-and-technology-efffect

Figure 1: The efffect of EGR on the speed.

Effect of EGR on the Fuel Consumption

The fuel consumption increased as the load the engine with EGR. As shown on the Table 3 the minimum was 0% and the maximum was10%. The average fuel consumption increment was 4.8%. More fuel was consumed to compensate for EGR dilution as shown in the Figure 2.

engineering-and-technology-consumption

Figure 2: The effect of EGR on fuel consumption.

Effect of EGR on the Brake Specific Fuel Consumption

When the speed reduced and fuel consumption increased, the brake specific fuel consumption increased. The increments range from 5.6% to 19.8% with average of 13.6%, as shown in Table 3. This was shown in the Figure 3.

engineering-and-technology-brake

Figure 3: Effect of EGR on the brake specific fuel consumption.

Effect of EGR on the Exhaust Gas Temperature

Table 3 above shows that for the exhaust gas temperature, the minimum reduction is 16% and maximum reduction is 28% while the average temperature reduction is 22%. Since the exhaust temperature reduced the NOX formation reduced as shown in Figure 4. The ratio of reduction of exhaust gas temperature to reduction of speed and increment of the fuel consumption is 5:2:1.

engineering-and-technology-exhaust

Figure 4: Effect of EGR on exhaust gas temperature.

Conclusion

When 2.6% of the exhaust gas recirculated into the engine there were following effect on the parameters of the engine:

a) Significant reduction in the exhaust gas temperature i.e., the flame temperature of the engine reduced by 22%.

b) Increment in fuel consumption i.e., fuel consumption increased by 4.8%.

c) Decreased in the speed of the engine i.e., the brake power reduced by 7.5%.

The percentage of the flame temperature reduced is more than the percentage of power reduced and fuel economy increased. EGR is the effective way to reduce the pollution of oxides of nitrogen without increase in the other pollutants in the internal combustion engine. There was significant reduction in the flame temperature below 10% EGR.

References